- Increased airflow for vapor cooling.
- High Grade Glass
- Easy to Attach
- Works with Existing Mouthpiece (Not a Replacement)
We recommend distilled water, or at least purified water, so that the flavor of your material is not affected. Also, as the water heats during usage, any contaminants, chlorine, etc., in the water will be activated and inhaled, which is the basis for our recommendation.
Filling the Herbva X Bubbler
Step 1: Turn the Herbva X bubbler upside-down (i.e., bottom facing up), and slowly pour about one teaspoon of water into the bubbler. The water should flow into the upper-portion of the bubbler.
Step 2: Flip the bubbler 180° so that the mouthpiece is facing up. Gently suck on the mouthpiece to make the water bubble, which will create a vacuum seal to hold the water inside the upper-section of the bubbler. NOTE: the water level should be below the upper-tip of the inner glass fill indicator. Flip the bubbler over, give it a little shake to remove excess water, then suck again to ensure no water is being sucked into your mouth while inhaling.
Step 3: Fill your Herbva X dry herb vaporizer with material, insert the standard mouthpiece, turn it on, set the desired temperature, and install the bubbler by simply placing it over the top of the Herbva X’s mouthpiece. You may have not noticed it but at the very bottom of the standard mouthpiece, where it connects to the vape body, is a rubber grommet. This little piece of rubber is what holds the water bubbler firmly in place over the mouthpiece.
Emptying the Herbva X Bubbler
Turn the bubbler upside-down so the base is facing your mouth. Hold the bubbler over a sink, and blow into the bottom of the bubbler. All water inside the bubbler should spray out the mouthpiece end of the bubbler.
Although this video shows a different water bubbler, for the Focusvape product, the concept is the same as for the Herbva X water bubbler.